Tascam CC-222MK CD Player User Manual


  Open as PDF
of 36
 
22 TASCAM CC-222MKIII
Restricting the number of tracks
When making a recording, it is possible to restrict the
number of tracks that may be recorded at one time.
At any time within record or record standby mode, turn
the MULTI DIAL control or use the SKIP keys.
This sets the number of remaining tracks, as shown to
the right of the time display.
The maximum number can be entered is 99 tracks
Every time a track division is made, the number shown
at the right of the display goes down by one.
The number of remaining tracks can be changed during
recording using the MULTI DIAL control.
Playing back tracks
Although an unnalized disc cannot be played back
on an ordinary CD player, the CC-222MKIII can
play back tracks that have been recorded. Use the
MULTI DIAL control or the SKIP keys to select a
track for playback.
NOTE
Because of the background noise often experi-
enced when playing back analog vinyl recordings,
the use of the following features is not recom-
mended in the phono recording mode even though
they are available: trigger level, sync recording and
automatic track division.
To record to disc from an external record player con-
nected to the RIAA PHONO INPUT jacks:
1 Loadarecordablediscandputtheunitinstop
mode.
2 Pressthe MENUkeyuntilthePHONO > XXX
menuitemisshown.
TurntheMULTI DIAL(orpresstheSKIPkeyson
theremotecontrol)toselectDISC.Prepareto
playtherecordontheexternalrecordplayer.
3 PressthePHONOkey.TheiNPuT 1,PhONO indica-
torlightsonthedisplay,andthediscrecorder
entersrecordstandbymode.
4 Startplayingbacktherecord.
5 Startrecordingonthediscbypressingthedisc
PLAYkey.
ThelevelcanbeadjustedusingtheCDdeck’s
INPUTcontrol.
Recordingwillstopwhentherecordingtime
onthediscends,orwhenthediscSTOPkeyis
pressed.Also,theRIAA PHONOinputsourcewill
becanceled.
NOTE
Only the disc STOP key is enabled in this phono
recording mode. The RECORD key therefore can-
not be used for manual track increments (see
Recording to disc from the RIAA PHONO inputs
5- Recording CDs Recording CDs
Full disc
If the disc becomes full during recording, the unit will
automatically insert a fade-out. For example:When
recording a long program, just before the end of the disc
is reached, the unit starts a fade-out over four seconds
and the display will show Fade Out.
When the fade-out has finished, the display shows
Disc Full!. Press the STOP key to exit.
If the disc is a CD-RW, the final track can be erased, if
required (see “Erasing” on page 27) and the disc then
finalized. If the disc is a CD-R, it must be finalized
prior to use (see “Finalizing” on page 27).
During recording, three options are available for the
time display modes.
When in record or record standby mode, repeated
presses of the DISPLAY key cycles through display-
ing the remaining time left for recording on the disc
(TOTAL REMAIN), the elapsed time of the track cur-
rently being recorded (no indicator lit) and the total
time recorded on the disc (TOTAL).
NOTE
In record mode, REMAIN shows the same time dis-
play as TOTAL REMAIN.
Time display while recording
 previous next