Tascam CC-222MK CD Player User Manual


  Open as PDF
of 36
 
1- Introduction
TASCAM CC-222MKIII 23
When dubbing from tape to disc, follow the instructions
here.
1 Loadthetapewiththesidethatwillberecorded
rsttobeplayedrst.Setthenoisereduction,
reversemode,etc.Also,checktheMONITORis
setDISC.
2 Loadarecordabledisc.
3 UsetheMENUkeyuntilDUB>VOLappearson
thescreen.Usethe MULTI DIALtoselectTHRU to
bypasstheinputlevelcontrol(see“Bypassingthe
inputlevelfordubbing”onpage23).
Ifyouwanttoadjusttheinputvolume,setthe
DUB>VOLmenutoONandusetheCDdeck’s
INPUTcontroltoadjustthelevelofsignals.If
youwishtoadjustthevolumebeforerecording
starts,puttheCD-RWintorecordstandbyor
Monitormode(see“Inputmonitoringonpage
20”)andusetheINPUT 1 SELkeytoselectTAPe.
4 PresstheDUB 1key.
TheCDgoesintorecordstandby.Thetapere-
windstothestartofthetapeandstartsplaying
back.TheCDrecorderstartsrecording.
5 Whentheavailablerecordingtimeonthediscis
nished,orthetapehasstopped,thenrecording
willstoponthedisc.
Youcanalsostopthedubbingprocessbypress-
ingeitheroftheSTOPkeys.
NOTE
A recordable disc must be loaded in the drive. The
DUB 1 key is disabled if the media are not loaded,
and if the drives are in any mode other than stop.
Dubbing to CD from the middle of the
tape
1 Torecordfromthemiddleofthetape,setnoise
reduction,reversemode,etc.andlocatethetape
tothepositionwhereplaybackwillstart.
2 PressthetapePAUSEkeytoleavethetapein
pausedmode.
3 Witharecordablediscinthedrive,pressthe
DUB 1key.Thetapewillstartplayingback,and
thediscwillstartrecording.
Recordingstopsunderthesamecircumstances
asforthewholetape(endoftape,endofdiscor
eitherSTOPkeypressed).
Dubbing from tape to disc
5- Recording CDs Recording CDs
Bypassing the INPUT level for dubbing
The input control can be bypassed so that it has no
effect when dubbing, in the following way:
1 PressthemenukeyuntiltheDUB>VOLitemap-
pears.
2 TurnthedialtoselectTHRU,thecontrolisby-
passedanddisabled.
NOTE
This setting applies only to dubbing procedures,
not to other recordings.
It is not possible to make this menu setting (or other
menu settings) when dubbing is actually taking
place.
”Manually divide track” on page 25). If you want to
use manual track division, use the normal recording
procedure, with the phono inputs selected as the
source.
This mode cannot be entered if a recordable disc is
not loaded in the drive.
It is also possible to perform manual recording to disc
from the RIAA PHONO INPUT source. This is the same
as the standard manual recording procedure (“Basic
recording” on page 21), except that the PhONO input
option should be selected using the INPUT 1 SEL key
before recording starts.
 previous next