Tascam CC-222MK CD Player User Manual


  Open as PDF
of 36
 
16 TASCAM CC-222MKIII
WARNING
If you are monitoring using headphones, first adjust
the level control to low on the unit, then connect to
the PHONES jack before playing back. This will pre-
vent any possible damage to your hearing.
1 PresstheOPEN/CLOSEkeytoopenthedisctray.
2 Discsshouldbeinsertedinthetraywiththelabel
uppermost.
3 PresstheOPEN/CLOSEkeytoclosethetray.
When a disc is loaded into the unit, the display briefly
shows TOC Reading., with a flashing period as the
unit determines the contents of the disc. When the TOC
has been read, the display shows (at the left of the dis-
play) one of the following:
CD Commercial pre-recorded CD
CD-R/CD-RW Finalized CD-R or CD-RW
CD-R, NO TOC CD-R which has yet to be finalized
CD-RW, NO TOC CD-RW which has yet to be finalized
Simple playback operations
4 PressthePLAYkeytostartplayback
5 PresstheSTOPkeytostopplayback
6 PressthePAUSEkeytopauseplaybacktempo-
rarily.
Toresumeplayback,pressthePAUSEkeyagain
orthePLAYkey.
The track number indicators at the bottom of the dis-
play light, to show the available tracks playing back.
If there are thirteen tracks on the disc, for example,
indicators 1 through 13 will light. If there are more than
20 tracks on the disc, “OVeR” will light at the end of the
track number indicators.
Time display modes
When playing back a CD, or when in standby mode,
there are four different time display modes.
In each mode, the current track number is given, fol-
lowed by the time, as given below, e.g.
10Tr 0:48
Press the DISPLAY key to cycle through these time dis-
play modes, as described here:
Display shows Meaning
TOTAl Total elapsed time of the disc
TOTAl ReMAiN Time remaining of the current disc
[blank] Elapsed time of the current track
ReMAiN Time remaining of the current track
NOTE
If the Program playback has been selected (see
”Program playback” on page 17), the elapsed time
and total remaining time refer to the programmed
material, not the whole disc.
Track search
Use the MULTI DIAL (or the SKIP keys on the remote
control unit) to jump forward or backward by one track
at a time, as shown on the display.
Note that going forward from the last track of the disc
will “wrap round” to track 1, and going backward from
the first track of the disc will “wrap round” to the last
track of the disc.
It is also possible to use the number keys on the remote
control unit to jump directly to a particular track:
1 Toplaytracks1through9,simplypresstheap-
propriatekey(1through9).
2 Toplayatrackwhosenumberishigherthan
9,pressthe+10keyanappropriatenumberof
timestosetthe“ tens”digitofthetracknumber,
followedbyasinglekeytosetthe“ units”digit.
Forexample:
Track13=+10,3
Track30=+10,+10,+10,0
NOTE
On the remote control unit only, the search keys
can be used to ”fast-forward” and ”fast-rewind”
through the disc.
4- Disc operations
 previous next