Filter
Top Products
1- Introduction
10 TASCAM CC-222MKIII
Do not expose the infrared receiver (light receptive
area on the front panel) to direct sunlight or intense
light for extended periods of time. Long exposure to
this light may result in failure of the remote control
sensor.
When the remote control will not be used over one
month, please remove the batteries to prevent the
possibility of battery acid leakage which could dam-
age the unit. Should leakage occur, remove and
discard the batteries, and wipe the battery case thor-
oughly with a cloth. Avoid getting the battery liquid
on the skin. After cleaning, replace with new batter-
ies.
•
•
The remote control functions by using an infra-
red light signal. When using the unit to control the
CC-222MKIII, other devices that are turned on could
be operated by its signal.
If the range of remote operation becomes smaller,
or commands do not always function properly, the
batteries have become weak and should be replaced.
Always replace both batteries with new batteries of
the same type.
Point the remote control to the remote sensor on
the main unit. Do not obstruct the path between the
remote control and the remote sensor.
•
•
•
Use of the remote control unit
If batteries are used improperly, or if leakage or break-
age occurs, the unit will not function.
Please observe the cautions indicated on the batteries
and their packaging to ensure proper usage.
Confirm + and – polarity and follow the indications
when inserting new batteries into the remote control.
Do not use old and new batteries together.
Even if the battery is the same size, the voltage may
differ. Do not use batteries of different specifications
together.
Do not attempt to recharge batteries that are non-
rechargeable.
Do not open or disassemble batteries, throw them
into a fire or put them in water.
•
•
•
•
•
Batteries
Inserting batteries
1. Open the lid.
2. Conrm+/-polarity,andinserttwoAAAbatteries.
3. Closethelid.
ª