Filter
Top Products
5
SCANNING OPERATION
40
■ Program scan
This is the most useful basic scan for searching over a spec-
ified frequency range.
1. Select program scan channel
q Push [V/M] to select VFO mode (p. 11).
w While pushing
[FUNC], push
[
(4)
PROG-S].
Rotate [DIAL] to se-
lect the program scan
channel.
Displays “PROGRAM
SCAN” with program
channel number and
the names for 2 sec.,
then scan edges, “S”
and “E”, are dis-
played.
VFO
FM
00
PROGRAM SCAN
4
PROG-S
FUNC
+
E: 146.0000
VFO
FM
02
PROGRAM SCAN
VFO
FM
S: 144.0000
[DIAL]
Displays "
S (start)" and "E
(end)" frequencies after 2
sec.
2. Start and stop scanning
Push [SCAN] to start
scanning.
To change the direction of the scan, rotate [DIAL] during
scanning.
When the program skip
function is ON (p. 61), fre-
quencies stored in BANK R
memories are skipped.
Also, “SKIP” is displayed.
Push [CLR] or [SCAN] to stop scanning.
When the same frequency is stored in both scan edges,
program scan will not proceed.
The default frequency range is 144.0000–146.0000
MHz. Set up scan frequency ranges before starting pro-
gram scan. See page 57 for program scan channel set
up.
VFO
FM
144.0000
SCAN
Flashes while scanning
VFO
FM
144.0000
SKIP
Skip indicator