Filter
Top Products
1. Turn power ON
Push [POWER] for 1 sec. to turn
power ON.
•Opening message is displayed for 1
sec.
BASIC OPERATION
3
10
■ General
Operating the IC-R10 is easy. However,
in order to get the most out of its oper-
ating potential, please go through the
following procedures, step-by-step.
Then, try the examples contained at the
end of this chapter.
What is VFO?
The IC-R10 has several operating
modes, each of which has its own dis-
tinct functions. VFO (Variable
Frequency Operation) is one of these
modes.
VFO mode is used to change the oper-
ating frequency, receive mode, tuning
step, etc. Therefore, for most every day
operations of the receiver, you will be
using VFO mode.
■ Selecting VFO mode
2. Adjust the volume
Adjust the audio to a suitable level
using [VOL].
Check the squelch position (see next
page) or VSC function setting (p. 38)
if no audio is emitted.
VFO
FM
Presented
by ICOM
Opening message as
above is displayed on the
multi-function display.