Filter
Top Products
3
BASIC OPERATION
15
■ Tuning a frequency (via the dial)
When you want to listen to frequencies
near the displayed frequency, the easi-
est way to tune them is with the tuning
dial.
All signals have what is called an “oc-
cupied bandwidth.” They will be re-
ceived as long as the receiver is tuned
anywhere within this bandwidth. Even
though the frequency received may not
be the central frequency, the tuning
step should be made as small as pos-
sible (0.5 or 5 kHz) and the receiver
tuned to the point of greatest signal
strength indicator deflection.
To change frequencies faster than the
tuning step, use the dial select function
(p. 16).
1. Select VFO mode and
a receive mode
q Push [CLR] or [V/M] to select VFO
mode.
w Push [MODE] to select a receive
mode.
e Set tuning step if desired (p. 14).
2. Tune a frequency
Rotate [DIAL] to change the fre-
quency.
•The frequency changes in increments
determined by the tuning step.
•To change the frequency faster, use the
dial select function (p. 16).
1
2