Filter
Top Products
Setting Up
41
GB
Setting up the MW/LW loop aerial
Note
Keep the MW/LW loop aerial away as far as
possible from the player. If you do not, noise may
be heard.
3 Connecting the mains lead
Insert one end of the supplied mains
lead to the AC IN socket located at the
rear of the player, and the other end to
the mains.
Changing the MW tuning interval
If you need to change the MW tuning
interval (preset to 9 kHz at the factory), do
the following:
1 Press RADIO BAND•AUTO PRESET
until “MW” is displayed.
2 Press YES•ENTER for 2 seconds.
3 Press RADIO BAND•AUTO PRESET for
2 seconds.
“MW 9” or “MW 10” flashes.
4 Turn the jog dial to select “MW 9” for
9 kHz interval or “MW 10” for 10 kHz
interval.
5 Press YES•ENTER.
After changing the tuning interval, you need
to reset your preset MW radio stations.
About the demonstration mode
The player enters the demonstration mode
about 10 seconds after you connect the
mains lead to the mains outlet.
Demonstration indications such as
“Demonstration Mode” appear in the display
one after another.
The player also enters the demonstration
mode if you do not operate the player for
about one minute after you turned it on.
To exit the demonstration mode, set the
clock of the player (page 35), or press
NO•CANCEL for about 2 seconds.
Tip
The sound quality may be changed depending on
the polarity of the mains plug. Change the
direction of inserting the plug and check the sound
quality.
4 Inserting batteries into the remote
Insert two R6 (size AA) batteries (not
supplied).
Replacing batteries
With normal use, the batteries should last for
about six months. When the remote no
longer operates the player, replace all the
batteries with new ones.
To improve the MW/LW
reception
Connect a 6- to 15-meter (20- to 50 feet)
(not supplied) insulated wire to the MW/LW
ANTENNA terminal. Keep the wire as
horizontal as possible near the window or
outdoor. You do not need to disconnect the
supplied MW/LW loop aerial.
Important
When you use an outdoor aerial, be sure to
connect the U terminal to earth against lightning.
To prevent a gas explosion, do not connect the
ground wire to a gas pipe.
Insulated wire
(not supplied)
Earth