Filter
Top Products
Optional Components/Additional Information
61
Additional Information
Precautions
On operating voltage
(For the model with the voltage
selector)
• Before operating the system, check that the
operating voltage of your system is identical with
the voltage of your local power supply.
• The voltage selector is located at the rear of the
apparatus.
On safety
• The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.
• Unplug the system from the mains if it is not to be
used for an extended period of time.
To disconnect the mains lead, pull it out by the
plug. Never pull the cord itself.
• Should any solid object or liquid fall into the
system, unplug the system and have it checked by
qualified personnel before operating it any further.
• AC power cord (mains lead) must be changed only
at the qualified service shop.
• When you connect the mains lead to the mains,
even if the power is off, the system begins charging
for remote and timer functions. Therefore the
surface of this unit become warm, this is normal.
On placement
• Make sure the system fan is on during use.
Place the system in a location with adequate air
circulation, and do not place anything on top of the
system.
• Place the system in a location with adequate
ventilation to prevent heat build up.
• Do not place the system in an inclined position.
• Do not place the system in locations where it is;
– Extremely hot or cold
– Dusty or dirty
– Very humid
– Subject to vibrations
– Subject to direct sunlight.
continued
AM aerial
Connect a 6- to 15- meter insulated wire to the
AM aerial terminal. Leave the supplied AM loop
aerial connected.
Insulated wire
(not supplied)
AM
Important
If you connect an external aerial, connect a ground
wire to the U terminal. To prevent a gas
explosion, do not connect the ground wire to a gas
pipe.