Filter
Top Products
47
The MD Deck — Editing/Tuner
To tune in a station with a weak
signal
1 Press TUNING MODE repeatedly until
“MANUAL” appears in step 3.
2 Press m or M repeatedly to tune in the
station and continue from step 5.
To set another station to the
exist preset number
Start over from step 2.
To change the AM tuning
interval (except for the European
model)
The AM tuning interval is factory-set to 9 kHz (10
kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
the system. While holding down the TUNING +
button, turn the system back on. When you change
the interval, all the AM preset stations are erased.
To reset the interval, repeat the same procedure.
Tips
• When a new station is memorized, the station
formerly memorized at that preset number is erased.
• The preset stations are retained for about a week
even if you disconnect the mains lead or if a power
failure occurs.
3 Press TUNING MODE repeatedly until
“AUTO” appears.
4 Press m or M.
The frequency indication changes and the
scanning stops when the system tunes in a
station. “TUNED” and “STEREO” (for a
stereo programme) appear.
When you want to stop scanning, press
TUNING MODE.
5 Press MENU/NO then . or >
repeatedly until “P.Memory ?” appears,
then press ENTER/YES.
The preset number flashes.
6 Press . or > to select the preset
number you want, then press ENTER/
YES.
The station is stored.
Select 1 to 20 for FM, and select 1 to 10 for
AM.
7 Repeat steps 2 to 6 to preset other
stations.