Filter
Top Products
60
Connecting external
aerials
Connect an external aerial to improve reception.
FM aerial
Connect an commercially available FM external
aerial, or you can use a TV aerial instead.
Jack type A
IEC standard socket
connector (not supplied)
Jack type B
75-ohm coaxial cable
(not supplied)
When “OVER” lights up during
recording from the connected
components
A signal in excess of the specified level was input
during recording. Perform the following
operations and then record the source again.
1 Press MENU/NO twice during recording or
recording pause.
“Setup Menu” appears.
2 Turn l/L until “Level Adjust ?”
appears, then press ENTER/YES.
3 Turn l/L to adjust the recording level.
The recording level can be adjusted from –12 to
+12. Make sure that “OVER” does not appear
in the display at the loudest portion.
4 Press ENTER/YES.
5 Press MENU/NO.
Note
If “OVER” appears in the display when the recording
level is between –12 and 0, change the audio input
level and reduce the input sound (see page 59).
Connecting an analogue
component (continued)