Filter
Top Products
5
Getting Started
Preparation
Stack the components vertically in the order
shown in the illustration below.
1 Connect the supplied digital cable to
DIGITAL OPTICAL OUT on the CD
player and DIGITAL OPTICAL CD
IN 1 on the MD deck.
Take the caps off the connectors, then insert
the plugs until they click into place.
IN 2
CD
AUX
DIGITAL OPTICAL
DIGITAL
OPTICAL
SYSTEM CONTROL 3
IN 1
SYSTEM CONTROL 2
OUT
2 Connect the system cables to the
SYSTEM CONTROL connectors on
each component.
Connect the tuner and
amplifier
Connect the system cable on the amplifier to
the SYSTEM CONTROL 1 (white)
connector on the tuner.
SYSTEM CONTROL 1
SYSTEM CONTROL 1
Connect the tuner and CD
player
Connect the supplied system cable to the
SYSTEM CONTROL 2 (black) connectors
on the tuner and on the CD player.
Connect the tuner and MD
deck
Connect the supplied system cable to the
SYSTEM CONTROL 3 (red) connectors on
the tuner and on the MD deck.
Notes
• The system cable is used to send signals and
electricity between the components for
interlinked operation.
Be sure to insert the connector horizontally
until it clicks into place. Otherwise the system
will not operate correctly.
• Keep the system cable away from the aerials
to prevent noise or malfunction.
continued
Tuner
Amplifier
CD player
MD deck