[ Getting Started ]
30
Vent Mount Method (C)
When assembling the vent clip, note that the lower arm may be attached in two different posi-
tions. You should assemble the vent clip in the configuration that works best in your particular
vehicle. Figure 5 illustrates both possible configurations of the vent clip.
To mount the car dock using the vent mount method, assemble the mount as follows, as
shown in Figure 6:
Attach the vent clip to mounting bracket 1 using the hex screws and nuts provided.
Attach mounting bracket 2 to mounting bracket 1, placing a collar into bracket 1 before
screwing bracket 2 to bracket 1. The side of the collar with the hole should face mount-
ing bracket 2.
Attach the car dock to mounting bracket 2 using the provided screws.
Slide the vent clip portion of the mount into a vent in your vehicle, insuring that one of
the vent louvers slides between the upper and lower portions of the two clip arms, and
hooks the rear of the louver.
1.
2.
3.
4.
Figure 5Figure 5