Filter
Top Products
ENGLISH
9
6. CONNECTING PREOUTs
• Use these jacks when adding additional power amplifiers.
• Connect the PREOUT jacks to the powered speakers or the power amplifiers connected to speakers respectively.
• When using only one surround back speaker, connect the SURROUND BACK LEFT jack to the power amplifier.
• If this is the case, you can connect the subwoofer without built-in amplifier to SURROUND BACK RIGHT terminals of the
power amplifier.(For details, refer to “When selecting the SUBWOOFER” on page 53.)
• To emphasize the deep bass sounds, connect a powered subwoofer.
Notes :
• After installing the speakers , first adjust the speaker settings according to your environment and speaker layout (For details,
refer to “SETTING THE SPEAKER SETUP” on page 49.)
• According to speaker settings, you cannot use either SURROUND BACK RIGHT jack or both of SURROUND BACK jacks.
7. CONNECTING SYSTEM CONTROL
• Connect this jack to the DIGI LINK jack of the external
Sherwood component that uses the DIGI LINK II or III
remote control system.
8. CONNECTING DC TRIGGER OUT
• Connect a component to DC TRIGGER OUT jack that
allows DC 12 V to turn on or off when a specfic input
source is selected or not.
• For details, refer to the operating instructions of the
components to be connected.
• To link DC TRIGGER OUT with a specific input source,
refer to “When selecting the DC TRIGGER SETUP” on
page 61.
Notes :
• This output voltage (12 V d.c., 100 mA ) is for (status)
control only, it is not sufficient for drive capability.
• When making DC TRIGGER connection, you should use
the stereo mini cord, not a mono mini cord.
Power amplifiers
CENTER
FRONT
L
R
SURROUND
L
R
SURROUND BACK
L
R
powered
subwoofer
Center speaker
Front speakers
Surround speakers
Surround back speakers
System
control
cord
Sherwood component
with DIGI LINK II or III
CD player
Tape deck
DVD player
Component to be triggered
by DC when a specific input
source is selected