Filter
Top Products
ENGLISH
29
Operate the selected component for
playback.
5
Select the tone mode as desired.
7
Select the digital or the analog input as
desired.
4
At the tone defeat mode, each time the MULTI
CONTROL knob is rotated, the tone defeat mode
changes as follows:
DEFEAT ON : When listening to a program source
without the tone effect.
DEFEAT OFF : When adjusting the tone for your
taste.
At the desired tone (bass or treble), each time the
MULTI CONTROL knob is rotated, the tone level
can be adjusted within the range of +10~ -10 dB.
• In general, we recommend the bass and treble to be
adjusted to 0(flat) level.
• To complete tone adjustment, repeat the above steps
and .
• Extreme settings at high volume may damage your
speakers.
• Each time this button is pressed, the tone mode
changes as follows:
BASS TREBLE DEFEAT OFF(or ON)
• The tone display is shown for several seconds.
• If the tone display disappears, press the TONE
MODE button again.
• ( ) : When the tone defeat function is activated
(“DEFEAT ON”), bass and treble modes
cannot be selected
Note:
• When the pure audio function is activated, the tone
mode cannot be selected.
• When playing back the program sources with
surround sound, refer to “ENJOYING SURROUND
SOUND” on page 34.
Adjust the (overall) volume.
6
At the desired tone mode, adjust as
desired.
8
When CD, AUX or VIDEO 1~ VIDEO 4 is
selected
Adjusting the tone (bass and treble)
• Each time this button is pressed, the corresponding
input is selected as follows:
DIGITAL ANALOG
• When TUNER or TAPE MONITOR is selected as an
input source, the analog input is automatically
selected.
Notes:
• When the selected digital input is not connected,
“DIGITAL” is flickering, meaning no sound.(Refer to
“ENJOYING SURROUND SOUND” on page 34.)
• To select the digital input, you should assign the
connected DIGITAL IN to the corresponding input
source. (For details, refer to “When selecting the
DIGITAL INPUT SETUP” on page 57.)
DOWN
UP
or
or