Filter
Top Products
ENGLISH
20
• If any of buttons fails to operate as they should,
start from the step again to find the correct setup
code.
Repeat the above steps to for each of your other components.
7
Searching a setup code
Perform the steps and in “Entering a
setup code” procedure on page 19 to select
the setup code mode (“CODE”).
2
Turn on the component you want to
operate.
1
While “PRESET” is displayed, press the
ENTER button to store the setup code.
4
Repeat the above steps to for each of
your other components
6
• Each time the CURSOR UP( )/DOWN( )
buttons are pressed, the setup code is selected one
by one.
• If the selected code is correct, your component will
be turned off.
• When your component is not turned off, repeat this
step until you find one that works.
• In addition to enter a setup code using “Setup Code
Table” on page 73, it is also possible to search
through all the codes that are stored in the library of
this remote control.
• Then “OK” is displayed on the LCD screen.
While “PRESET” is displayed, search a
setup code, aiming the remote control at the
remote semsor on the component.
3
Operate the component using the
corresponding function buttons.
5
Operate the component using the corresponding function buttons.
6
• If any of buttons fails to operate as they should , start from the step again to enter the correct setup code.
Notes:
• Manufacturers may use different setup codes for the same product category. For that reason, it is important that you check to see
if the code you have entered operates as many controls as possible. If only a few functions operate, check to see if another code
will work with more buttons.
• When operating a Sherwood CD player or tape deck using the system remote control, aim the remote control at the REMOTE
SENSOR on this receiver.
However, in case of Sherwood DVD player and MD recorder, aim it at the REMOTE SENSOR on the corresponding component.