Filter
Top Products
ENGLISH
22
Erasing the programmed command
from one button
While “BTTN” is displayed, press the
CURSOR UP(
)/DOWN( ) buttons to
select the one command deleting mode
(BTTN), then press the ENTER button.
2
Perform the steps and in “Entering a
setup code” procedure on page 19 to select
the delecting mode (“DELETE”).
1
While “SEL” is flickering, repeat the above
step
to erase other commands.
4
To erase all the commands programmed
under other device mode, repeat the above
steps to .
4
• “OK” is displayed and then “SEL” is flickering.
• Then “BTTN” is displayed on the LCD screen for
several seconds.
• Each time the CURSOR UP(
)/DOWN( ) buttons
are pressed, “BTTN” or “LEARN”(all command
deleting mode) is selected.
• Then “SEL” is flickering.
• If “BTTN” goes off, start again from the above step
.
While “SEL” is flickering, press the button
for the command you want to erase.
Example) When the button for the command to be
erased is PLAY button
3
Erasing all the commands
programmed under a device mode
While “BTTN” is displayed, press the
CURSOR UP( )/DOWN( ) buttons to
select the all command deleting mode
(“LEARN”), then press the ENTER button.
2
Perform the steps and in “Entering a
setup code” procedure on page 19 to select
the deleting mode (“DELETE”).
1
•Then all the commands programmed are erased.
• Then “BTTN” is displayed on the LCD screen for
several seconds.
• Then “SURE?” is displayed .
• If “SURE?” goes off, start again from the above
step
While “SURE?” is displayed, press the
ENTER button
3