Filter
Top Products
54
Press the CURSOR LEFT( )/RIGHT( )
buttons to select the desired crossover
frequency.
2
• You can select the desired within 40~120 Hz in 20 Hz
intervals(default value: 80 Hz).
• For speakers set to “Small”, sound with a frequency
below the selected crossover frequency is cut, and
instead the cut bass sound is output from the
subwoofer or speakers which are set to “Large”.
Example) When 100 Hz is selected, the bass sound
below 100 Hz is output from the
subwoofer or large front speakers(when
not using a subwoofer).
Press the CURSOR UP(
)/DOWN( )
buttons to select the CROSSOVER
FREQUENCY.
1
When selecting the CROSSOVER
FREQUENCY
• Crossover frequency is the frequency (Hz) below
which the bass sound of each main speakers is to
output from the subwoofer or from front speakers
which are set to “Large”(when not using a
subwoofer).
• Each time these buttons are pressed, the mode
changes as follows :
LFE: Select this when the subwoofer reproduces only
the low Frequency Effects from multi-channel
sources that contain LFE channel, also called
the “.1” channel.
LFE + SW: Select this when the subwoofer reproduces
not only the Low Frequency Effects but
also the bass sounds from stereo(2
channel) analog or PCM sources only.
• Regardless of subwoofer mode setting, the bass
sounds of the speakers set to “Small” can be sent to
the subwoofer.
Press the CURSOR UP(
)/DOWN( )
buttons to select the SUBWOOFER
MODE.
1
Press the CURSOR LEFT( )/RIGHT( )
buttons to select the desired mode.
2
When selecting the SUBWOOFER MODE
ENGLISH