Filter
Top Products
ENGLISH
or
DOWN
UP
37
Enter the test tone mode.
1
• The volume level of each channel can be adjusted easily with the test tone function.
Note: When speakers are switched off , the test tone function does not work.
Cancel the test tone function.
3
Adjusting each channel level with test tone
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows:
FL FC FR SR
Front Left Center Front Right Surround Right
SUB SL ( SC) or ( B L BR)
SUBwoofer Surround Left (Surround Center) (Surr. Back Left Surr. Back Right)
• Depending on the speaker setting(None or No), the
test tone of the corresponding channel is not
available.
• ( ): possible depending on whether the surround back
channel is set to 2 CH or 1 CH.
At each channel, adjust the level as desired
until the sound level of each speaker is
heard to be equally loud.
2
• You can select the desired channel and adjust its
level with repeating the steps
and in
“Adjusting the current channel levels” procedure.
Adjusting the current channel levels
Select the desired channel.
1
• After adjusting each channel level with test tone, adjust the channel levels either according to the program
sources or to suit your tastes.
• If you have performed the CH LEVEL SETUP procedure on the OSD menu, you can memorize the adjusted
channel levels into preset memory(PRESET 1, PRESET 2) and recall the memorized whenever you want.
(Refer to “SETTING THE CH LEVEL SETUP” on page 66.)
or
• Each time this button is pressed, the corresponding
channel is selected as follows:
FRONT-L FRONT-C FRONT-R SURR-R
SUBWOOFER
SURR-L ( SURR-C) or ( BACK-L BACK-R)
• Depending on the speaker settings and surround
mode, etc., some channels cannot be selected.
• ( ): possible depending on whether the surround back
channel is set to 2 CH or 1 CH.
Note: When speakers are switched off, only
FRONT-L and FRONT-R channels can be
selected.