Filter
Top Products
Rack Mounting
The rack mounting brackets come with each RKP-4. These
brackets may be used to mount a single base station in a 19” wide
rack or mount two base stations side by side in a rack. Figure 5-1
shows the three brackets that come with a base station.
Rack Mounting a Single Base Station
1. Remove the four pan head screws (two on each side)
closest to the front panel.
2. Place the double unit side bracket on the side of the base sta-
tion you wish closest to the edge of the rack.
3. Replace the two pan head screws and use a third pan head
screw (2 supplied with base station) to screw into the
upper middle location of the bracket.
4. Place the single unit rack mount bracket on the other
side of the base station.
5. Replace the two pan head screws and the other pan head
screw that came with the base to secure the bracket.
Screw the third screw into the upper middle hole of the
bracket.
6. Use the rack mount screws (not supplied) to secure the unit to
the rack.
Rack Mounting Two Base Stations
Side-by-Side
1. Remove the four pan head screws (two on each side)
closest to the front panel.
2. Place the double unit side brackets on the sides of the
base stations you wish closest to the edge of the rack.
3. Replace the two pan head screws and use a third pan
head screw (2 supplied with base station) to screw unto
the upper middle location of the rack mount middle
bracket.
4. Place the dual bracket on the other sides of the base sta-
tions. Make sure the bracket is flipped so the front bend
is toward the front of the base station. As you face the
rack, the right base station will have the middle bracket
front bend high and left base station will have the bend
low.
5. Replace the two pan head screws and the other pan head
screw into the upper middle hole of each bracket.
6. Use the four flat head screws (2 supplied with base sta-
tion) to secure the top and bottom of the middle brack-
ets together.
7. Use rack mount screws (not supplied) to secure the unit to
the rack.
Figure 5-1
Rack Mount Brackets
Figure 5-2
Rack Mounting of a Single Unit
Figure 5-3
Rack Mounting Two Base Units Side-by-Side
5-2