Filter
Top Products
84
Troubleshooting
Multi-Effects / Reverb / LFO Does
not Applied
Is not the [MULTI-EFFECTS] button light? (p. 20)
Press [MULTI-EFFECTS] to make it light.
Is “OFF” selected for the REVERB Type (p. 25)
or MULTI-FX/LFO (p. 25, p. 36) ?
Select a setting other than “OFF.”
Is the Reverb Send in the PAD SET or PAD (p.
25, p. 36) lowered?
Raise the values.
MIDI-related Problems
No Sound when using an
external controller (sequencer,
keyboard etc.)
Is the MIDI cable connected properly? (p. 78)
Is the MIDI channel correct? Or is the
channelset to “OFF?”
Select the correct MIDI channel (p. 78).
Bulk Dump Is Not Transmitted
Is the MIDI cable connected properly?
If you wish to save a bulk dump on an external device,
connect the HPD-15’s MIDI OUT/THRU connector to the
external sequencer’s MIDI IN connector (p. 80).
Has the “No reception of MIDI Exclusive
Messages” setting been selected on the
external MIDI device?
Refer to the owner’s manual for the external MIDI device.
Sequencer-related Problems
No Sound When [PLAY/STOP] is
Pressed
Is it a blank pattern that is being played
back?
Play back a pattern containing performance data.
Is “Ext” selected for the “Seq Sync?” (p. 68)
Select “Int.”
Playback Stops Immediately
After Beginning
Is “Tap” or “TapVelo” selected for the
pattern’s PlayType?
Select “Loop” or “OneShot” (p. 60).
“Tap” and “TapVelo” refer to the convenient playback
function in Pad Pattern (tapping the pad causes the pattern
to be played back).