Filter
Top Products
78
Chapter 6 Connecting MIDI Devices
Using the HPD-15 As a
Sound Module
Make settings for playing the HPD-15 as a sound module
from a MIDI keyboard or other device.
Use a MIDI cable to connect the HPD-15’s MIDI IN connector
to the MIDI OUT connector of an external keyboard,
sequencer, etc.
fig.6-04.e
Setting the MIDI Channel for a
Part
For each part, you can specify the channel on which the
HPD-15 will receive and transmit MIDI messages.
1. Press [SYSTEM] and make it light.
2. Press [ PARAMETER] or [PARAMETER ] to
display the following screen.
fig.6-05
3. Turn [PATCH/VALUE] to specify the channel.
Pad CH: 1–16, OFF
Specify the channel on which performance data of the pad
controller section (pads, D Beam, ribbons, external triggers)
will be transmitted and received. Normally you will set this
to channel 10.
Perc 1 CH: 1–16, OFF
Specify the channel for percussion part 1 of the internal
sequencer. Normally you will set this to channel 11.
Perc 2 CH: 1–16, OFF
Specify the channel for percussion part 2 of the internal
sequencer. Normally you will set this to channel 12.
Melo 1 CH: 1–16, OFF
Specify the channel for melody part 1 of the internal
sequencer. Normally you will set this to channel 5.
Melo 2 CH: 1–16, OFF
Specify the channel for melody part 2 of the internal
sequencer. Normally you will set this to channel 6.
At a setting of “1” through “16,” MIDI messages will be
transmitted and received on that channel. A setting of “OFF”
lets you turn off transmission and reception for that part, so
that notes are not received.
* When you are finished setting, press [SYSTEM] or [EXIT].
For more on synchronization with external sequencer, refer
to “Synchronizing the Internal Sequencer with an External
MIDI Device” in “Settings for the Basic Operation” (p. 68).
MIDI INMIDI OUT
MIDI keyboard
HPD-15
MIDI
Pad CH 10