Filter
Top Products
83
Appendices
Troubleshooting
This chapter outlines points to check if you experience
problems, and what to do about them.
Problems With the Overall
Sound
Intended Sound Not Produced
Are the pad sensitivity settings correct?
Make sure that the following parameters are set to correct
value.
System Settings:
PAD Sens (p. 70), DBEAM Sens (p. 69)
Patch Settings:
PadSnsType (p. 54), TrigMode (p. 36)
The HPD-15 adjusts the sensitivity of the D Beam
autmatically for the brightness of its location when the power
is turned on. Do not shut the window of the D Beam until the
patch name is displayed.
If you connect the hi-hat control pedal (FD-7, optional), the
HPD-15 check the position of the pedal when the power is
turned on. Do not step on the pedal until the patch name is
displayed.
No Sound
Has the [VOLUME] knob (p. 10) turned fully
counterclockwise?
Turn the [VOLUME] knob clockwise.
Has the left realtime modify knob (p. 19)
turned fully counterclockwise?
Press [SELECT] to make the upper indicator light. Then turn
the left realtime modify knob ([LEVEL]) clockwise to increase
the level.
Are the PAD SET Level (p. 25), Pad Level (p.
36), and MasterVolume (p. 54) in the patch
lowered?
Raise the values.
Are the Effect Level, Direct Level, and FxOut
Volume (p. 40) in the multi-effects lowered?
Raise the values.
Is “Off” selected for the Pad Inst? (p. 36)
Select a instrument other than “Off.”
Is “OFF” selected for the Local Control? (p. 80)
Select “ON.”
Is not the [SOUND] button of D Beam or
ribbon light?
Press [SOUND] to make it light.
Are the cables connected to the correct jacks?
Connect the cables to the OUTPUT jacks.
The Volume Level of the
Instrument Connected to OUTPUT
Jacks is Too Low
Could you be using a connection cable that
contains a resistor?
Use a connection cable that does not contain a resistor.
Sound Does Not Stop
Is the [ROLL/HOLD] button light? (p. 16)
Press [ROLL/HOLD] to make it dark.
Is “Gate” or “Trig” selected for the
“TrigMode?” (p. 36)
Select “Shot.”
Is the window of the D Beam shut? (p. 16)
Be careful not to shut the window of the D Beam.
Modification Does not Change
the Sound
Is the selected pad correct?
The pad which is hit last becomes edit target.
Is “OFF” selected for the “Pad Chase?” (p. 68)
When “OFF” is selected, edit target does not change. Select
“ON” for the Pad Chase or Strike the pad to select it while
holding down [PATCH SEL].
Is Modify Lock (p. 19) on?
When the [SELECT] indicator is blinking, there is a pad
which is fixed to the target of modification. Hold down
[SELECT], and press [EXIT] to unlock.