Filter
Top Products
62
Chapter 3 Recording Your Performance (Sequencer)
Settings for the Recording (Set in the Recording Stand-by mode)
fig.3-10.e
You can start recording by pressing [PLAY/STOP] at every screen above.
Rehearsal Function
The rehearsal function is a feature that temporarily suspends
recording during recording. This allows you to practice the
phrase while Loop recording is in progress.
1. Start recording.
2. Press [REC] while recording.
[REC] will blink, and the rehearsal function will be on.
Performances cannot be recorded.
3. Press [REC] to resume recording.
[REC] will light and the rehearsal function will be off.
Using the controllers (D Beam, ribbons, pad pressure, etc.)
too much will increase the consumption of memories. If you
wish to reduce the data, refer to the explanation of “Data
Thin” in “Settings for the Controllers” (p. 69).
Specifying the Recording Method
Regularizing the Timing of Performance Data When Recording
RecMode
Quantize
Loop All, Loop 1,
Loop 2, Loop 4,
Loop 8, Replace
1/8, 1/12, 1/16, 1/24,
1/32, 1/48, 1/64, OFF
OFF, ONSpecifying How to Start the RecordingHitPadStart
Loop All: The entire pattern will be repeated, and on each pass your performance
will be added, ("over-dubbed") and mixed with what you did previously.
This corrects inaccuracies of timing while you record.
OFF: Recording starts when [PLAY/STOP] is pressed.
1/8–1/64: Data will be quantized to the note of the tempo of the sequencer.
Specifying the Part
RecStby
Perc1, Perc2,
Melo1, Melo2,
Import
Perc1, Perc2: Percussion Part 1, Percussion Part 2
* When you select Perc1, Perc2, Melo1, or Melo2, all channel data is received.
You do not need to change the channel of the MIDI deveice connected to the HPD-15.
Parameter Value
ON: Recording starts when you start the performance on pads/D Beam/ribbons.
OFF: The pattern is recorded with the timing used in performance.
Replace: Recording will continue until you press [PLAY/STOP]. Any previously
recorded data for all Parts will be erased.
Loop 1, Loop 2, Loop 4, Loop 8: This determines the length of the section you are
recording, and 1, 2, 4 or 8 measure section will repeat.
Import: Select this when you will record multiple Parts simultaneously by
using an external sequencer. Each Part will receive the data from
specified MIDI channel (p. 78).
Melo1, Melo2: Melody Part 1, Melody Part 2