Filter
Top Products
53
Chapter 2 Modifying a Patch
Chapter 2
Cutoff:
Modifies the cutoff frequency of the filter. The character
of the high-frequency range will change.
Resonance:
Modifies the resonance of the filter. The range near the
filter cutoff frequency will be emphasized.
Color 1–2:
Simultaneously changes the filter cutoff frequency and
resonance. The tonal character will change.
RevSend -, RevSend +:
Modifies the depth of the reverberation.
LFO Rate * :
Modifies the modulation rate of the LFO waveform.
LFO Pitch * :
Modifies the depth of the pitch modulation produced by
the LFO.
LFO Fltr * :
Modifies the depth of the tonal change produced by the
LFO.
LFO Amp * :
Modifies the depth of the volume change produced by
the LFO.
LFO Pc&Rt * :
Modifies the depth of the pitch modulation produced by
the LFO and the speed of modulation.
LFO Ft&Rt * :
Modifies the depth of the tonal change produced by the
LFO and the speed of modulation.
LFO Am&Rt * :
Modifies the depth of the volume change produced by
the LFO and the speed of modulation.
MFX Ctrl1–3 * :
Modifies the parameter value of the multi-effect. The
parameter that will be controlled will depend on the
selected effect. Please refer to “Adjusting Multi-Effect
Settings” (p. 40). If you select MFX Ctrl1, parameters
marked by “Ctrl1” can be controlled. The same applies
to MFX Ctrl2–3.
RollSpeed * :
Changes the speed at which the roll will repeat. The
same effect can be obtained even if [ROLL/HOLD] is not
lit.
Tempo -, Tempo +:
Adjusts the tempo of the sequencer.
TurnTable * :
An effect will be produced as though you were manually
rotating the turntable of a record player.
Play/Stop:
Controls sequencer play/stop. This is the same operation
as pressing [PLAY/STOP] on the panel.
* This cannot control sequencer start/stop in the Recording
Stand-by Mode (p. 59).
When CtrlTx is set to any value marked with a "*," the effect
can be obtained even with pads (ribbons, D Beam, etc.) for
which Ctrl Rx has been set to OFF.
CtrllrType: Posit, Speed
Specifies how the D Beam, ribbon, and pedal will transmit
signals. If you select Posit, the transmitted signal will change
according to the position at which your hand is located
relative to the controller. If you select Speed, the transmitted
signal will change according to the speed at which you move
your hand.
* The pad will be displayed as “---” and cannot be set.