Filter
Top Products
70
Chapter 5 Settings for the Entire HPD-15
Setting the Pad Sensitivity
If you wish to make more detailed settings, set the following parameters.
fig.5-06.e
To set Sens, Threshold, Mask Time, and Pressure Sens, strike
the pad that you wish to set. The selected pad number will
appear in the display.
1 – 16
PAD Sens
Adjusting the Sensitivity
Setting Minimum Levels
Adjusting the Volume of the Edge Sound
Adjusting the Edge Area
Preventing Double Triggering
Adjusting Pad Pressure Sensitivity
Threshold
Edge Level
Edge Area
Mask Time
Pressure Sens
0 – 64ms
1 – 16
Once a pad has been hit, any additional trigger signals occuring within
the specified Mask Time will be ignored.
Adjust the sensitivity of pad to pressure. Increasing the value will increase the
sensitivity, so that it will be easier to transmit mute or pitch control signals.
Adjust the volume of the sound that is heard when you strike the edge of pads
A1 or A5.
Adjust the size of the area that will trigger the edge sound of pads A1 or A5.
Increasing this value will broaden the area that triggers the edge sound.
Increasing this value will raise the sensitivity and produce the larger sound
even if the striking force is the same.
A trigger signal to be transmitted only when the pad is struck harder than a
specified force. This allows you to prevent the pad from picking up extraneous
vibrations from neighboring pads. If the striking force is less than the threshold,
the pad will not sound.
1 – 16
1 – 16
1 – 16
* Increasing this value will lose certain notes if you play very fast. Set this value
as short as possible.
* To have the unit sound even when struck lightly, set the threshold as low as possible.
Parameter ValueCategory