Filter
Top Products
38
Chapter 2 Modifying a Patch
Adding Cyclic Change to the
Tone
You can use the LFO (Low Frequency Oscillator) to cyclically
change the pitch, volume, etc.
* The LFO will apply to all pads / D Beam / ribbons.
Parameter Category: PAD LFO
fig.2-10
Waveform: OFF, Triangl, Sine, SawRise,
SawFall, Square, Trape, Smp&Hld,
Random, Chaos
Selects the waveform of the LFO. If you select OFF, there will
be no change, and the following parameters will not be
displayed.
fig.2-11.e
Rate: 0–127
Adjusts the modulation rate of the LFO waveform.
PitchDepth: 0–127
Adjusts the depth of the pitch modulation.
FilterDepth: 0–127
Adjusts the depth of the modulation in tone.
AmpDepth: 0–127
Adjusts the depth of the modulation in volume.
EffectDepth: 0–127
Adjusts the depth of modulation for the effect parameter. For
details on the parameter that will be modulated, refer to
“Adjusting Multi-Effect Settings” (p. 40).
Realtime2: PITCH, EFFECT
Selects the LFO parameter which is modified by turning the
middle realtime modify knob. You can modify the
PitchDepth if you select the PITCH, or the EffectDepth if you
select the EFFECT.
This parameter is effective only when the bottom indicator
that at the upper right of the Realtime Modify knobs is lit by
pressing [SELECT].
Realtime3: FILTER, AMP
Selects the LFO parameter which is modified by turning the
right realtime modify knob. You can modify the FilterDepth
if you select the FILTER, or the AmpDepth if you select the
AMP.
This parameter is effective only when the bottom indicator
that at the upper right of the Realtime Modify knobs is lit by
pressing [SELECT].
U0101 LFO
Waveform Triangl
Triangl Sine SawRise
Square
Trape
Smp&Hld Random Chaos
SawFall
Triangle wave Sine wave Sawtooth
wave (Up)
Sawtooth
wave (Down)
Square wave Trapezoidal wave
Chaos waveRandom wave
Sample and
hold wave