Filter
Top Products
42
Chapter 2 Modifying a Patch
Enhancer
The Enhancer controls the overtone structure of the high
frequencies, adding sparkle and tightness to the sound.
Sens: 0–127 LFO, Ctrl1
Adjusts the sensitivity of the enhancer.
Mix: 0–127 RTM, Ctrl2
Adjusts the ratio with which the overtones generated by the
enhancer are combined with the direct sound.
Low EQ: -15–+15dB
Adjusts the level of the low frequency range.
High EQ: -15–+15dB Ctrl3
Adjusts the level of the high frequency range.
Spectrum
Spectrum is a type of filter which modifies the timbre by
boosting or cutting the level at specific frequencies. It is
similar to an equalizer, but has 5 frequency points fixed at
locations most suitable for adding character to the sound.
Band 1: -15–+15dB
Adjusts the 500 Hz level.
Band 2: -15–+15dB LFO, Ctrl1
Adjusts the 1 kHz level.
Band 3: -15–+15dB
Adjusts the 1.25 kHz level.
Band 4: -15–+15dB Ctrl2
Adjusts the 3.15 kHz level.
Band 5: -15–+15dB
Adjusts the 4 kHz level.
Width: 1–5 Ctrl3
Simultaneously adjusts the width of the adjusted areas for all
the frequency bands.
Pan: L63–Center–R63
Adjusts the stereo location of the output sound.
TotalLevel: -15–+15dB RTM
Adjusts the output level.
Isolator
The Isolator is a stronger version of an equalizer, and is able
to completely cut a specific frequency range.
Low Level: 0–127 Ctrl3
Adjusts the level of the low frequency.
Mid Level: 0–127 LFO, Ctrl1
Adjusts the level of the middle frequency.
High Level: 0–127 Ctrl2
Adjusts the level of the high frequency.
Pan: L63–Center–R63
Adjusts the stereo location of the output sound.
TotalLevel: -15–+15dB RTM
Adjusts the output level.
Dynamic Filter (DynamicFltr)
The Dynamic Filter varies the tone by moving a filter
according to the volume.
Filter Type: LPF, BPF
Selects the type of filter.
LPF: The wah effect will be applied over a wide
frequency range.
BPF: The wah effect will be applied over a narrow
frequency range.
Sens: 0–127 Ctrl2
Adjusts the sensitivity with which the filter is controlled.
Manual: 0–127 RTM, LFO, Ctrl1
Adjusts the center frequency from which the effect is applied.
Peak: 0–127 Ctrl3
Adjusts the amount of the wah effect that will occur in the
area of the center frequency. Lower settings will cause the
effect to be applied in a broad area around the center
frequency. Higher settings will cause the effect to be applied
in a more narrow range.
Pan: L63–Center–R63
Adjusts the stereo location of the output sound.