Filter
Top Products
12
Parts and their functions
GND terminal
Use to ground the unit.
DC12V IN terminal
Connects the AW-PS505A AC adapter (sold separately).
TALLY IN connector
Connect this to the TALLY connector on the video
switcher or other units.
When the TALLY connector is set to the GND level, the
TALLY lamp () lights. Do not apply a voltage in excess
of 5 V to this connector.
Pin No. Signal Name
1 TALLY1
9 TALLY2
2 TALLY3
10 TALLY4
3 TALLY5
11 TALLY GND
4 –––
12 –––
5 –––
13 –––
6 –––
14 –––
7 –––
15 –––
8 –––
REMOTE/SERVICE connector
A personal computer or other external equipment is
connected here when a pan/tilt head system is to be
controlled by these equipments.
Pin No. Signal Name
1 –––
2 RXD IN
3 TXD OUT
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 –––
REMOTE/SERVICE switch
(Setting at shipment: R)
Function selection switch for the REMOTE/SERVICE
connector. Set the switch in the “R” position during use.
TALLY5
TALLY3
TALLY1
TALLY2
TALLY4
TALLY GND
R
5 4 3 2
1/EXT
S
TALLY IN
REMOTE/SERVICE
TO PAN/TILT HEAD
MONITOR SELEC
T
DC12V IN
GND
Pin layout as seen from the
back of AW-RP555
Rear connector panel