Filter
Top Products
22
1. Select the pan/tilt head system using the CONTROL
button.
2. Shoot a white object (such as a white wall or
handkerchief) to fill the whole screen using the pan/tilt
head system currently selected.
Do not allow shiny, reflective or very bright objects to
appear on the screen.
3. Press the WHITE BAL A button, and press the AWC
button. The AWC button’s lamp flashes, and the white
balance is automatically adjusted. Once the adjustment
has been performed correctly, the lamp goes off, and the
conditions set are entered in channel A.
The AWC button’s lamp will remain lighted if it was not
possible for the adjustment to be performed. In this case,
change the brightness, iris, object, light source, etc., and
perform the adjustment again.
The AWC button’s lamp goes off even if the white
balance adjustment was not performed correctly in
cases where a pan/tilt head system other than the
AW-PH350, AW-PH360 or AW-PH650 is being used.
4. Similarly, enter the conditions set for channel B using the
WHITE BAL B button.
5. Select the next pan/tilt head system using the CONTROL
button, and continue adjusting the white balance in each
system concerned.
White balance adjustment
The white balance must be adjusted when the equipment
is used for the first time, when it has not been used for a
prolonged time or when the lighting conditions or brightness
has changed.
The white balance conditions can be entered in advance
into channels A and B.
If the equipment is to be used under conditions which are
identical to the entered settings, it means that no further
adjustment need be undertaken since the white balance
will be set simply by pressing the WHITE BAL A button or B
button once the white balance has been adjusted.
When the white balance is adjusted again, the previously
entered settings will be deleted and replaced by the new
conditions.
Automatic adjustment of white balance
When the WHITE BAL ATW button is pressed during
shooting, the ATW button’s lamp comes on, compensation
is provided so that the white balance will be automatically
adjusted even if the light source or color temperature has
changed in order to minimize an unnatural appearance in
the resulting images.
If nothing white is shown on the screen, it may not
be possible for the white balance to be compensated
properly.
Similarly, with some light sources or color temperatures,
it may not be possible for the white balance to be
compensated properly.
Automatic tracing white balance (ATW)
Operation
1
LEVEL
IRIS
OPERATE
CAM
CONT
2 3 4
ATW
ITEM
DEF
WIP
H/F
(AF)
EXT
LAMP
ND OP
SCENE FILE
PRESET
MENU
YES
NO
B
A
SHUTTER
MODE
GAIN
5
2
ON
OF
F
ON
OFF
3 4 5
ABC
MEMORY
MENU
Multi Hybrid Control Panel AW-RP555
AWC
OK
NG
WHT BAL
3
2
1
USER
TALLY
CONTROL
HIGH
LOW
TELE
WIDE
FAR
LEFT RIGHT
UP
DOWN
NEAR
MANU
AUTO
SPEED
ZOOM
FOCUS
PAN/TILT
1 2 3 4 5
6 7 8 9 10
MANU
AUTO
0dB
L
H
CAM
BAR