Filter
Top Products
24
1. Select the pan/tilt head system using the CONTROL
button.
2. Use the following buttons to establish the modes.
Press the IRIS button to establish the MANU mode
(the IRIS button’s lamp now goes off).
If the AUTO mode is established, the lens iris position
will not be entered.
3. Operate the ZOOM lever and PAN/TILT lever, and on the
monitor check the pictures which are to be shot.
4. Select the white balance from among the A, B and ATW
buttons, and adjust the lens iris using the IRIS LEVEL
control.
5. Set the unit to a state in which the MEMORY button is
held down.
When the MEMORY button is pressed, those buttons
among the PRESET buttons 1 through 10 in which data
can be entered start flashing in sequence.
6. While the MEMORY button is held down, press the
button in which the preset memory data is to be entered.
7. If necessary, enter other shooting positions and settings
into other buttons among PRESET buttons 1 through 10
as preset memory data.
8. Select the next pan/tilt head system using the CONTROL
button, and continue setting the preset memory data for
each system concerned.
Entering preset memory data
Preset memory settings
The multi hybrid control panel is equipped with a preset
memory function for entering the positions and settings with
which the pan/tilt head system is to shoot.
Preset memory data is entered into PRESET buttons 1
through 10.
Pan/tilt head system’s settings
Pan/tilt head:
Pan/tilt position
Camera:
Zoom, focus, iris (MANU mode only), white balance
Operation
1
LEVEL
IRIS
OPERATE
CAM
CONT
2 3 4
ATW
ITEM
DEF
WIP
H/F
(AF)
EXT
LAMP
ND OP
SCENE FILE
PRESET
MENU
YES
NO
B
A
SHUTTER
MODE
GAIN
5
2
ON
OF
F
ON
OF
F
3 4 5
ABC
MEMORY
MENU
Multi Hybrid Control Panel AW-RP555
AWC
OK
NG
WHT BAL
3
2
1
USER
TALLY
CONTROL
HIGH
LOW
TELE
WIDE
FAR
LEFT RIGHT
UP
DOWN
NEAR
MANU
AUTO
SPEED
ZOOM
FOCUS
PAN/TILT
1 2 3 4 5
6 7 8 9 10
MANU
AUTO
0dB
L
H
CAM
BAR
1. Select the pan/tilt head system using the CONTROL
button.
2. Press the OP button while holding down the MEMORY
button.
3 The OP button lamp starts flashing, and the standby
mode is established.
4. Press the OP button to establish the setting mode.
The lamps of the PRESET 1 to 10 buttons start flashing
in sequence. If the joystick is operated at this point, the
deletion operation will be forcibly terminated.
5. Press the PRESET buttons whose memory data is to be
deleted.
6. If necessary, delete other preset memory data as well.
Deleting preset memory data