Filter
Top Products
6
Parts and their functions
SHUTTER button
This is used to select the shutter speed of the camera in
the pan/tilt head system currently selected.
Each time the button is pressed, the set shutter speed is
switched to shutter OFF or vice versa.
The shutter speed is actually switched as soon as the
button is released.
At any setting except OFF, the button’s lamp lights; at the
OFF setting, it is off.
[How to register the shutter speed]
1. Press the SHUTTER button while holding down the
MEMORY button.
2. The PRESET [1 to 5] buttons and PRESET [6 to 10]
buttons start flashing alternately.
3. Press the PRESET button that corresponds to the
shutter speed to be registered.
The table below lists the shutter speeds which can be
set.
1/100 PRESET 1 1/4000 PRESET 6
1/250 PRESET 2 1/10000 PRESET 7
1/500 PRESET 3 SYNCRO-SCAN PRESET 8
1/1000 PRESET 4 ELC PRESET 9
1/2000 PRESET 5 OFF PRESET 10
When OFF is set, the shutter will not be operated
even when the SHUTTER button is pressed.
Select the SYNCRO-SCAN setting from the camera
menu.
The change in the shutter speed is reflected when
the shutter is next set to ON.
This setting is retained in the memory even after the
control panel’s power has been turned off.
[ When temporarily changing the shutter speed without
registering it]
Press the PRESET button corresponding to the shutter
speed to be set while holding down the SHUTTER button.
Refer to the table above for the shutter speeds which can
be set.
The shutter speed will be changed as soon as the
PRESET button is pressed.
This setting will be cleared when either the shutter button
is pressed or the camera’s power is turned off.
WHITE BAL [A/B/ATW] buttons
These are used to select the camera’s white balance
adjustment in the pan/tilt head system currently selected.
A: When the A button is pressed, the white balance
status entered in the camera’s memory A is
established, and the A button’s lamp comes on.
If the AWC button is pressed after the A button
was pressed, the white balance is automatically
adjusted and entered in the camera’s memory A.
B: When the B button is pressed, the white balance
status entered in the camera’s memory B is
established, and the B button’s lamp comes on.
If the AWC button is pressed after the B button
was pressed, the white balance is automatically
adjusted and entered in the camera’s memory B.
ATW: When the ATW button is pressed, the white
balance is set to the automatic adjustment
mode, and the ATW button’s lamp comes on.
1
LEVEL
IRIS
OPERATE
CAM
CONT
2 3 4
ATW
ITEM
DEF
WIP
H/F
(AF)
EXT
LAMP
ND OP
SCENE FILE
PRESET
MENU
YES
NO
B
A
SHUTTER
MODE
GAIN
5
2
ON
OFF
ON
OFF
3 4 5
ABC
MEMORY
MENU
Multi Hybrid Control Panel AW-RP555
AWC
OK
NG
WHT BAL
3
2
1
USER
TALLY
CONTROL
HIGH
LOW
TELE
WIDE
FAR
LEFT RIGHT
UP
DOWN
NEAR
MANU
AUTO
SPEED
ZOOM
FOCUS
PAN/TILT
1 2 3 4 5
6 7 8 9
10
MANU
AUT
O
0dB
L
H
CAM
BAR