Filter
Top Products
18
Operation
Turning on the power
1. Set all the power switches of the connected components
and the power switch of the AC adapter to ON.
2. Set this unit’s OPERATE switch to ON.
Power will be supplied to the pan/tilt head system
connected to this unit, and the camera’s initial settings
will be performed in sequence.
When the pan/tilt head system is connected (or changed)
and its power is turned on for the first time, the connected
cameras will be initialized. Upon completion of the
initialization, adjust or set the following items. After the items
are adjusted or set, proceed to the section entitled “Setting
the travel range (limiters) of the pan/tilt head”.
Once the adjustments are made, there is no need for any
re-adjustments unless changes are made to the pan/tilt
head, camera or lens. (The items to the re-set or re-adjusted
differ depending on the unit which is changed.)
EXTERNAL CONTROL OUT setting
Set this to ON when connecting the AW-DU600 dial up
adapter to the control panel’s TO PAN/TILT HEAD 1/EXT
connector. Normally, set it to OFF.
1. Press the LAMP button while holding down the
MEMORY button.
2. The LAMP button’s lamp starts flashing, and the standby
status is established.
3. Press the LAMP button to establish the setting mode.
The lamps of both the MEMORY button and LAMP
button start flashing, and the status currently set is
indicated as follows:
When the PRESET 5 button lamp is lighted:
EXTERNAL CONTROL OUT ON
When the PRESET 10 button lamp is lighted:
EXTERNAL CONTROL OUT OFF
4. Press the PRESET 5 button to set to EXTERNAL
CONTROL OUT ON.
Press the PRESET 10 button to set to EXTERNAL
CONTROL OUT OFF.
The lamps of both the MEMORY button and LAMP
button stop flashing, and the setting mode is exited.
It takes about 5 seconds to perform the camera’s
initial settings for each camera. The pan/tilt head
system cannot be controlled until these settings are
completed.
Be sure to set power switches on all connected
equipment and AC adapters to ON before setting
the control panel’s OPERATE switch to ON.