Filter
Top Products
20
Operation
Adjusting the minimum start
speed of the lens zoom
Perform this adjustment to ensure that the lens zoom will
function smoothly in response to the angle to which the
zoom lever is tilted when it is used to zoom the lens.
1. Use the CONTROL button to select the pan/tilt head
whose lens zoom minimum start speed is to be adjusted.
2. Press the IRIS button while holding down the MEMORY
button.
3. The IRIS button lamp starts flashing, and the standby
status is established.
4. Press the IRIS button to establish the setting mode.
The lamps of both the MEMORY button and IRIS button
start flashing. If the joystick is operated at this point, the
adjustment will be forcibly terminated.
5. Press the PRESET 1 to 8 buttons to set the
compensation amounts. This amount is lowest for
the PRESET 1 button and highest for the PRESET 8
button. When the PRESET 10 button is pressed, the
compensation is set to OFF. When the PRESET 1 to 8
and 10 buttons are pressed, the lamp of the IRIS button
stops flashing, and the setting mode is exited.
6. Move the zoom lever slowly and, while monitoring the
image on the monitor, check whether the lens zoom
starts moving smoothly.
If the lens zoom fails to starts moving smoothly, repeat
steps 2 to 5 and find the optimum value.
7. Repeat steps 2 to 6 for the other pan/tilt heads.
Setting the travel range (limiters)
of the pan/tilt head
Depending on where it has been installed, there may be
obstacles within the travel range of the pan/tilt head system
with which the system may come into contact.
The pan/tilt head system may malfunction or an accident
may occur if the system comes into contact with such an
obstacle.
Prior to use, be absolutely sure to set the travel range
(limiters: upper, lower, left-most and right-most limits of
rotation) of the pan/tilt head system.
Before installing a pan/tilt head as a stand-alone type, set
the installation direction switch inside the pan/tilt head to
stand-alone installation. (“Suspended installation” is the
factory setting.)
If this switch is not set properly, the operating directions
of the pan/tilt head will be reversed, and the limits of the
pan/tilt head’s travel range (limiters) will not be stored in
the memory properly. For details on how to set the switch,
refer to the operating instructions of the pan/tilt head.
1. Select the pan/tilt head system using the CONTROL
button.
2. Set the upper limit position in the travel range.
Operate the PAN/TILT lever on the control panel to
rotate the camera to the position which is to serve as
the upper limit position.
Press the PRESET 2 and 3 buttons while holding
down the MEMORY button on the control panel.
When the button 5 lamp lights, the setting is
completed.
To cancel the setting, press the PRESET 2 and 3
buttons again while holding down the MEMORY
button. When the setting is canceled, the button 10
lamp lights.
3. Set the lower limit position in the travel range.
Operate the PAN/TILT lever to rotate the camera
to the position which is to serve as the lower limit
position.
Press the PRESET 7 and 8 buttons while holding
down the MEMORY button.
When the button 5 lamp lights, the setting is
completed.
To cancel the setting, press the PRESET 7 and 8
buttons again while holding down the MEMORY
button. When the setting is canceled, the button 10
lamp lights.