Panasonic AW-RP555N Stereo Receiver User Manual


 
13
Parts and their functions
TO PAN/TILT HEAD 1/EXT terminal
• Functions as the pan/tilt head’s connection terminal 1
when the EXT CONTROL OUT is set to OFF on the
EXTERNAL CONTROL OUT setting (see page 18).
Connect a 10BASE-T straight cable (equivalent to UTP
category 5) to the pan/tilt head’s IP/RP terminal.
May be extended up to a maximum of 3,280 ft. (1,000 m).
Use the RS-232C/RS-422 converter and connect
to pan/tilt head’s RS-232C control terminal when
connecting to the AW-PH300, AW-PH300A, AW-PH500
or AW-PH600.
• Functions as the AW-DU600 dial up adapter’s connection
terminal when the EXT CONTROL OUT is set to ON on
the EXTERNAL CONTROL OUT setting (see page 18).
Connect a 10BASE-T straight cable (equivalent to UTP
category 5) to the AW-DU600’s PAN/TILT CONTROL IN
terminal. May be extended up to a maximum of 3,280 ft.
(1,000 m).
For more details, refer to the operating instructions
of the dial up adapter AW-DU600. Use the following
terms instead:
• AW-RP605
AW-RP555
• EXTERNAL CONTROL OUT terminal
TO PAN/TILT HEAD 1/EXT terminal
There are no software version restrictions for this unit
in systems with AW-DU600.
TO PAN/TILT HEAD 2 to 5 terminal
• Functions as the pan/tilt head’s connection terminals
2 to 5 when EXT CONTROL OUT is set to OFF on the
EXTERNAL CONTROL OUT setting (see page 18).
Connect a 10BASE-T straight cable (equivalent to UTP
category 5) to the pan/tilt head’s IP/RP terminal.
May be extended up to a maximum of 3,280 ft. (1,000 m).
Use the RS-232C/RS-422 converter and connect
to pan/tilt head’s RS-232C control terminal when
connecting to the AW-PH300, AW-PH300A, AW-PH500
or AW-PH600.
• Cannot be used when the EXT CONTROL OUT is set
to ON on the EXTERNAL CONTROL OUT setting (see
page 18).
MONITOR SELECT terminal
Connect a 10BASE-T straight cable (equivalent to UTP
category 5) to the AW-RC400 cable compensation
unit’s MONI SEL IN terminal. May be extended up to a
maximum of 164 ft. (50 m).
The video signal from the pan/tilt head system connected
to the input terminal, whose number is selected on this
unit, will be sent from the AW-RC400’s MONITOR 1, 2
terminals.
TALLY5
TALLY3
TALLY1
TALLY2
TALLY4
TALLY GND
R
5 4 3 2
1/EXT
S
TALLY IN
REMOTE/SERVICE
TO PAN/TILT HEAD
MONITOR SELEC
T
DC12V IN
GND