Filter
Top Products
31
Operations
Using the level sync function
3 Press the MULTI JOG dial.
Pressing the YES button provides the same
operation.
The level sync function turns off. Press the EDIT/
NO button to return to the previous setting.
Note:
This setting cannot be made during recording.
2 Press the MULTI JOG dial.
Pressing the YES button provides the same
operation.
The current setting appears. The current setting
is given on the left side (for the display given
below, the current setting is "On").
Using the level sync function
During analog recording, the track numbers are
assigned automatically since the level sync function is
turned on. Even so, you can press the o REC (or the
remote controller o REC button) to assign the track
numbers manually. To disable the automatic
assignment of track numbers during recording, turn
off the level sync function.
Turn off the level sync function and assign the track
numbers manually, if the numbers are not
automatically updated due to the situations as
follows:
For analog recording
The level sync function uses the recording source
level to detect the end and beginning of tracks.
Therefore, in the cases given below, the track
numbers may not be properly assigned.
• The recording on the cassette tape is poor (e.g.,
the space between songs contains much noise).
• With music such as classical music where there
may be very low volumes.
• Where the space between songs is extremely
short.
• If the signal at the tuner is weak (excessive
noise).
• When recording from turntables.
• When the level sync function is turned on, if no
signal continues for approximately one minute,
recording will stop.
For digital recording
• When digitally recording satellite broadcasts, the
track numbers may not be assigned properly. If
this occurs, turn off the level sync function and
set the track numbers manually.
• If the time between tracks is extremely short, the
track numbers may not be assigned properly.
• When the level sync function is turned on, if no
signal continues for approximately one minute,
recording will stop. However, you can continue
recording to CDs.
1 While in the recording standby state,
press the EDIT/NO button and turn the
MULTI JOG dial until "Level Sync?"
appears.
To return to automatic assignment of track
numbers
Switch the setting to ON.
Follow the steps 1 through 3. "Off → On" should
appear in step 2, "L.Sync On" in step 3.
MULTI JOG
PUSH TO ENTER
MULTI JOG
PUSH TO ENTER
EDIT / NO
PUSH TO ENTER
MULTI JOG