Filter
Top Products
30
7 Verify that "Signal Wait" is flashing
together with the time display and
then start the playback of the
recording source.
Recording starts as soon as the CDR-201A
receives signals from the recording source.
Notes on the signal synchronous recording
• When the level synch function is turned on
during analog recording, the track numbers are
updated automatically as soon as audible sound
is detected after 2 seconds or more of silence.
• If “Signal Wait” continues for 1 minute, signal
synchronous recording is cancelled and playback
is stopped.
• When "D.In Unlock" appears in the front display
during the signal synchronous recording (digital
input), the CDR-201A cancels the recording
mode and enter to the recording standby state.
4 Adjust the recording level.
Refer to page 24, step 4 "Adjust the recording
level."
5 Stop the playback of the recording
source.
6 Press the o REC button (or the remote
controller REC o button)
The CDR-201A enters the input standby state,
"Signal Rec" appears in the display, and then
"Signal Wait" appears flashing alternately with
the time display.
CDR-201A RC-448C
Synchronous recording by input signal detection
(Signal synchronous recording)
REC
REC