Filter
Top Products
26
Analog recording
Perform analog recording to record the signal input
to the analog input terminal of the CDR-201A. The
recording level can be adjusted manually.
Preparation
• Turn on the CDR-201A (see page 20).
• Place a recordable CD-R or CD-RW in the CDR-
201A (see page 20).
• Verify that the input dial and recording selection
button of the amplifier are set to the position of
the recording source.
1 Repeatedly press the INPUT button
until "Analog In" appears.
Proceed to step 3 if you do not wish to adjust
the recording level.
2 Start playback of the recording source.
3 Press the o REC button (or the remote
controller REC o button).
The level sync function turns on.
"Rec Setup" appears in the display followed by
the time display (the recording standby state).
4 Adjust the recording level
Refer to page 24, step 4 "Adjust the recording
level."
5 Stop playback of the recording source.
6 Press the n button (or the remote
controller s button) and start the
recording source.
Recording starts. If the entire disc becomes filled
with recordings, the CDR-201A automatically
stops.
To set the track numbers manually
Press the o REC button.
To pause the recording
Press the n button (or the remote controller g
button). To resume recording, press the n button
(or the remote controller s button) when the time
display appears.
The CD recorder will stop, if the recording standby
state persists for 10 minutes or more.
To stop the recording
Press the e button.
AUDIO CD RECORDER
DISPLAY
STANDBY / ON
STANDBY
INPUT
CD
DUBBING
REC
FINALIZE
EDIT / NOYES
PUSH TO ENTER
MULTI JOG
CDR
-
201A
STANDBY/
ON OPEN
/
CLOSE
RANDOMMEMORYREPEAT
NAMEABC DEF
231
SCROLL
GHI MNOJ
K
L
456
CLEAR
DISPLAY
ENTER
PQRS TUV W
XYZ
10
/
0
>
10
789
REC
RC-448C
INPUT
o
REC
s
EDIT/NO
n
YES
o
REC
Proceed to step 6 if you do not wish to adjust
the recording level.
º
INPUT
REC
REC
CDR-201A RC-448C