Filter
Top Products
23
Operations
Synchronous recording (component system operation)
AUDIO CD RECORDER
DISPLAY
STANDBY / ON
STANDBY
INPUT
CD
DUBBING
REC
FINALIZE
EDIT / NOYES
PUSH TO ENTER
MULTI JOG
CDR
-
201A
STANDBY/
ON OPEN
/
CLOSE
RANDOMMEMORYREPEAT
NAMEABC DEF
231
SCROLL
GHI MNOJ
K
L
456
CLEAR
DISPLAY
ENTER
PQRS TUV W
XYZ
10
/
0
>
10
789
REC
RC-448C
INPUT
o
REC
o
REC
For analog recording, select "Analog In."
Proceed to step 3 if you do not wish to adjust
the recording level.
Note:
Synchronous recording cannot be performed
when "Digital In 2" is selected.
2 Press the s button on the CD player
to start playback.
3 Press the o REC button (or the remote
controller REC o button).
"Rec Setup" appears in the display followed by
the time display (the recording standby state).
1 Repeatedly press the INPUT button
until "Digital In1" appears.
When connected to a component system, the
synchronous recording operations given below are
possible.
• Synchronous recording from the CD player to
the CDR-201A.
• Synchronous recording from the MD recorder or
tape deck to the CDR-201A.
• Synchronous recording from the CDR-201A to a
MD recorder or tape deck.
Synchronous recording from a CD
player to the CDR-201A
Preparation
• Turn on the CDR-201A (see page 20).
• Place the music CD in the CD player. (Refer to
the instruction manual for the C-701A.)
• Place a recordable CD-R or CD-RW in the CDR-
201A (see page 20).
Proceed to step 6 if you do not wish to adjust
the recording level.
INPUT
REC
REC
CDR-201A RC-448C