Filter
Top Products
TROUBLESHOOTING
Should faults occur, it is in many cases not necessary
to consult your dealer or technical service department.
On the basis of the following checks, you will be able
to rectify a number of conditions yourself without
difficulty. If the condition cannot be remedied after the
following check, please consult your dealer or contact
D & M Professional at 866 405 2154.
No Power
• check power cord connections
• switch POWER off then immediately back on
Recording does not contain tracks
• check that AUTO TRACK is ON
• check if there is 2.7 seconds of silence (analog)
• check that the digital source conforms to the
SPDIF or IEC-958-II standard
• is source a DVD video disc (DVD discs do not
contain track information)
No Sound
• check audio connections
• if using an amplifier or receiver,
• check amplifier or receiver settings
• check that a signal is present
• try a different amplifier or receiver
Sound distorted
• check that analog output is not connected to a
PHONE input
• check that disc is not defective (try another)
Recording distorted
• check recording level
• try another disc
XLR input too high or too low
• adjust record level
• adjust TRIM
Play will not start
• check that the label of the CD is facing up
• clean the disc
• check that disc is not defective (try another)
Remote control does not work
• check that EXT / INT (IR) switch on rear is at INT
• check drive selection (CDR or CD)
• point the IR remote control directly at the IR
receiver
• check or replace batteries
- 54 -
Will not record
• check input source selection (INPUT button
selection matches input source connected)
• check that disc is not an audio disc (WRONG
DISC display)
• clean the disc
• check if CD-R/RW is an unfinalized disc
• try another disc
• text memory full (MEMORY FULL/FINALIZE CD
display Erase CD Text for other disc(s) or finalize
other disc(s) to obtain memory space.)
DIGI flashing in display
• check digital cable connections
• try a different cable
• check that the output of the digital source con-
forms to the SPDIF or IEC-958-II standard
OPTI flashing in display
• check optical connections
• try a different connector
• check that the output of the digital source con-
forms to the SPDIF or IEC-958-II standard
DIGI flashing in display
• check digital cable connections
• try a different cable
• check that the output of the digital source con-
forms to the SPDIF or IEC-958-II standard
Disc playback quality on other players is poor
• check disc quality
• check that discs are compatible with 1X recording
• try 'Music' (consumer) blank discs
• if using 80 minute discs, try a 74 minute disc (they
provide a wider recording area and thus less
chance for error)
CD Text appears on CD drive but not CDR drive
• check disc (The CDR drive does not display CD
Text on 'hybrid' CDs that contain audio and data
together on the disc.)