Filter
Top Products
41
Recording on MD
Basic section
Each press switch the modes as follows.
1 "STEREO" : Stereo recording mode
2 "LP2" : Stereo LP2 recording mode
3 "LP4" : Stereo LP4 recording mode
4 "MONO" : Monaural recording mode
MD can be recorded in the desired recording modes (REC MODE) as required. (In stop mode only)
Long-hour recording modes (REC MODE)
1 Select the "MD" input.
2 If the "PGM" indicator is lit, turn it off by
pressing the PGM key in stop mode to can-
cel the program mode.
3 Press the REC MODE key.
4 When "LP2" or "LP4" is selected in step 3,
press the SET/DEMO key.
5 Turn the VOLUME/MULTI CONTROL knob to
select "LP : STAMP on" or "LP : STAMPoff",
then press the SET/ DEMO key.
REC MODE indicator
* In stop and record modes, one of the REC MODE indicators lights to show the set recording mode. In
play mode, the indicator showing the recording mode of the track being played lights.
LP 2
REC MODE
Stereo LP modes (LP2, LP4) : The stereo LP modes enables long hours of recording by adopting higher
digital audio compression rates than the stereo and monaural recording modes. The LP4 mode features
even longer recording time by adopting even higher compression rate than the LP2 mode.
If an MD recorded in the LP2 or LP4 mode is played back on a recorder/player incompatible with LP2/LP4 :
When a track recorded in stereo LP2 or LP4 mode is played back on an MDLP-incompatible recorder/
player, the disc can be played but no audio will be reproduced. When an MD containing tracks recorded in
stereo LP2 and LP4 modes and those recorded in the STEREO and MONO modes is played back, audio will
be reproduced only with the tracks recorded in STEREO and MONO modes. When playing such an MD, be
careful not to increase the volume setting during playback with no audio reproduction. Otherwise, a very
high volume will be reproduced when playback of a track recorded in the STEREO or MONO mode starts.
Stamping (STAMP) : This unit has the stamping function, which attaches stamp characters "LP:" at the
beginning of each track title to facilitate identification of tracks recorded in the LP2 or LP4 mode. "LP:"
can be displayed as a part of each track title only when the stamping function is set to on.
Note that "LP:" is displayed as a part of track title only when a track is recorded in stereo LP2 or LP4 mode
is played on an MDLP-incompatible recorder/player.
This unit allows you to select the STAMP function on ("LP:" attached to the title) or off ("LP:" not attached
to the title).audio reproduction. Otherwise, a very high volume will be reproduced when playback of a
track recorded in the STEREO or MONO mode starts.
Turning the knob switches the display contents.
1 "LP: STAMP on" :
Characters "LP:" are input
at the beginning of each track title.
2 "LP: STAMPoff" : Characters "LP:" are not in-
put at the beginning of each track title.
REC MODE
(Recording mode)
Goes off
REC MODE indicator
LP2 (Stereo LP2
recording mode)
LP4 (Stereo LP4
recording mode)
MONO (Monaural
recording mode)
STEREO (Stereo
recording mode)
MONO LP2 LP4
VOLUME/
MULTI CONTROL
SET/DEMO
\