Filter
Top Products
Controls and indicators
17
Preparation section
IMT E ADJUST
Example for adjusting at 1:30PM
This unit incorporates a clock function. Be sure to adjust the correct time before using the timer function.
÷ The time display starts to blink.
÷ Press the SET/DEMO key. The hour is entered and the
minute display starts to blink.
Blinks
If there is a power failure or the power cord is unplugged then plugged in again while the power set to off (STANDBY
mode) after a timer is activated, the STANDBY/TIMER indicator blinks in amber. In this case, adjust the clock again.
Select the time display mode.Blinks
÷ The time of the day is represented in 12-hour or 24-
hour method.
Switching the power ON
Activate the clock adjustment mode.
Enter the figure of hour.
2
1 Adjust the figure of hour by turning the
VOLUME/MULTI CONTROL knob.
2 Set it.
To increase
hour
To decrease
hour
1
1 Press the MODE key.
2 Turn the VOLUME/MULTI CONTROL knob
to select "TIME ADJUST", then press the
SET/ DEMO key.
3 Turn the VOLUME/MULTI CONTROL knob
to select "12 HOUR" or "24 HOUR", then
press the SET/DEMO key.
MODE
VOLUME/
MULTI CONTROL
Example for adjusting at 1:30PM
÷ If you pressed the SET/DEMO key by mistake, press
the MODE key and restart from the beginning.
÷ To adjust correct time, press the SET/DEMO key at
the same moment as a time announcement.
÷ When the STOP7/TUNING MODE key is pressed
while the power is in the standby mode, the time of the
day will be displayed for 5 seconds.
Enter the figure of minute.
3
1 Adjust the figure of minute by turning the
VOLUME/MULTI CONTROL knob.
2 Set it.
To increase
minute
To decrease
minute
SET/DEMO
SET/DEMO
VOLUME/
MULTI CONTROL
Clock adjustment
12> HOUR
P. S
k
H
PM
0
Blinks
P. S
k
H
PM
0