Filter
Top Products
74
Troubleshooting
●If this product does not function properly even after you have implemented the possible
solutions given above
Many functions of this product are implemented by microcomputers. If malfunction is caused by
thunder or static electricity, or the main unit does not function properly even when you press a
button, disconnect the power plug from the AC outlet, wait for a while, and then connect this
product again. Then reset the clock.
Problem Possible cause Possible solution
Reference
page
No sound/video is
produced.
Improper connection. Connect all cords properly. 15
Headphones are connected. Disconnect the headphone plug. 11
The clock display is
flashing.
A power failure occurred or the
power plug was disconnected.
Reset the clock. 19
Disc playback does not
start.
The disc is upside down.
Place the disc on the disc tray with
the letter-printed surface facing up.
24
Moisture has condensed on the
lens.
Leave the main unit turned on, wait
for approximately 1 or 2 hours, and
then operate the main unit.
3
A certain point cannot be
played back properly.
The disc is scratched or dirty. Clean or replace the disc. 72
An error occurred on the MD. Record to the MD again. 51
You cannot record an
MD.
The MD is write-protected. Cancel the write-protection. 72
A radio broadcast cannot
be received.
No antenna is connected. Connect an antenna. 14
A whirring noise is
produced.
The main unit is located close to a
TV, computer, or other electric
appliance.
Place the main unit away from a TV,
computer, or other electric appliance.
3
You cannot set the timer. You did not set the clock. Set the clock. 19
The timer does not work. The main unit is turned on.
After setting the timer, turn off the
main unit.
66, 68
You cannot operate the
remote control.
The remote control batteries are
running low.
Replace the batteries with new
batteries.
12
You cannot operate the
main unit with the number
buttons on the remote
control.
The remote control mode selector
on the remote control is set to TV.
Set the remote control mode selector
to AUDIO.
19
The sound is not
produced from the sub-
woofer.
The sub-woofer setting (SUB
WFR) is "OFF".
Turn on the sub-woofer setting (SUB
WFR).
40
NX-DV3[UJ].book 74 ページ ２００４年１２月２８日 火曜日 午後２時３７分