Filter
Top Products
10
NOTE
• When placing the surround speaker on a stand,
such as a speaker stand, attach the foot seals to
the surround speakers, depending on the way the
speakers are placed (
page 9
).
• When mounting the surround speakers on the
wall, pay attention to the following:
• Obtain screws that are strong enough to mount
the speakers to the wall.
• If the screws used are not strong enough or the
speakers are not properly mounted, the speak-
ers may fall down, causing injury or damaging
other equipment. If you are not sure about the
strength of the wall or other things, make sure
to consult with a specialist.
• Give careful consideration to the place to which
the speakers are mounted. If the speakers are
mounted in areas that get in the way in daily
lives or in locations where they can easily bump
into people, it may result in injury or damage to
the equipment.
Based on how the surround speakers are placed
( pages 8 and 9), set the speaker position.
■When the main unit is turned off
Press on the main unit.
Each time you press , the display
toggles as follows.
NOTE
• When nothing appears in the display window, press
to select "DISPLAY ON"( page 21), and
then set the speaker position.
Information on Speaker Display in
the display window
Sub-Woofer
When the sub-woofer is set to "OFF" (
page 40), or when headphones are being
used, the light is off.
The light is on when the left front speaker
signal is being input.
The light is on when the center speaker signal
is being input.
The light is on when the right front speaker
signal is being input.
The light is on when LFE signal is being input.
The light is on when the left surround speaker
signal is being input.
The light is on when the monophonic signal is
being input.
The light is on when the right surround speaker
signal is being input.
When the line under L, C, R, LS, or LR is on, the
sound is being played from that speaker.
Speaker Display shows input signals and the speaker
in use.
Setting the Speaker Position
: Select this when Pattern 1 is
used.
: Select this when Pattern 2 is
used.
: Select this when Pattern 3 is
used.
How to remove the speaker cover
When performing maintenance or other procedures,
you can remove the cover of the front speakers by
pulling the cover towards you.
• You cannot remove the cover of the surround
speakers.
NX-DV3[UJ].book 10 ページ ２００４年１２月２８日 火曜日 午後２時３７分