Filter
Top Products
47
English
5
Press SET when you find the point
where you want to divide the
track.
“POSIT. (position) 0” appears on the display,
and the unit repeats the selected point—a 3-second period
following the dividing point.
• If the loaded MD has 254 tracks, “DISC FULL” will
appear (see “MD limitations” on page 61) and you
cannot go to the following steps.
• If the dividing point is satisfactory, go to step
7
.
If not, go to the next step.
• To cancel the setting, press CANCEL, then repeat from
step
4
.
6
Press or to precisely
adjust the dividing point.
When you stop pressing the button,
the unit repeats the newly selected
dividing point.
• You can shift the dividing point up to ±128. This range
(±128) corresponds to approximately ±8 seconds* from
the original point (position 0).
* When the recording length mode of the selected track is “SP.”
For “LP2,” it is approximately ±16 seconds, and for “LP4”
approximately ±32 seconds.
• When you find the correct position, go to the next step.
• To cancel the setting, press CANCEL, then repeat from
step
4
.
7
Press SET.
8
Press ENTER.
“EDITING” appears on the display. Then
“WRITING” and the REC (MD recording)
indicator flash while the editing you have
made is being recorded on the MD.
To join the divided tracks, see the JOIN function on page
48.
In the following examples of track editing, the process is
explained from the very first—that is, inserting a disc. You
can also edit an MD during playback (in Normal Play).
Dividing a Track—DIVIDE
This function allows you to divide one track into two separate
tracks. It is useful, for example, when you want to add track
marks at a certain point within a track or if you want to
separate a recording.
When the original track has a title, two separate tracks are
reassigned the same title as the original track in the same
group (if the original track is belonged to a group).
Once a track is divided, the other tracks are renumbered.
• To stop any time during the editing process below before
step
8
, press TITLE/EDIT.
1
Insert an MD you want to edit into the MD
loading slot.
On the remote control ONLY:
2
Press TITLE/EDIT repeatedly
until “DIVIDE ?” appears on the
display.
• If the loaded MD has no track, “DIVIDE ?” will not
appear on the display.
• If you want to stop this editing process, press CANCEL.
3
Press SET.
The first track on the MD starts playback
repeatedly.
4
Press ¢ or 4 to select
the track you want to
divide.
• You can also select the track using
the number buttons.
• If you press and hold ¢ or 4, you can fast-forward
or fast-reverse the selected track.
Ex.: When adjusting the point by –103.
Ex.: When track 12 is selected.
TITLE/EDIT
SET
GROUP SKIP GROUP SKIP
SET
10 +10
SET
ENTER
EN46-53_UX-J55MD[UB]f.p65 7/1/03, 4:45 PM47