Filter
Top Products
40
English
Adding a Track to a Group—ENTRY GR
This function allows you to enter a track into a group. The
track will be added as the last track in the selected group.
The track numbers will be renumbered.
• To stop any time during the editing process below before
step
8
, press GROUP TITLE/EDIT.
1
Insert an MD you want to edit into the MD
loading slot.
On the remote control ONLY:
2
Press GROUP TITLE/EDIT
repeatedly until “ENTRY GR ?”
appears on the display.
• If you want to stop this editing process, press CANCEL.
3
Press SET.
• During playback:
The currently playing track number starts flashing.
4
Press ¢ or 4 to select
the track.
• You can also select the track using
the number buttons. In this case,
the selected track starts playback repeatedly.
GROUP TITLE
/EDIT
GROUP SKIP GROUP SKIP
5
Press SET.
• If the loaded MD has no group, you cannot go to the
following steps.
• When the selected track belongs to a group, its group
number appears on the display.
• To cancel the setting, press CANCEL, then repeat from
step
4
.
6
Press GROUP SKIP ¢ or GROUP SKIP
4 while holding SHIFT to select the group.
7
Press SET.
• To cancel the setting, press CANCEL, then repeat from
step
4
.
8
Press ENTER.
“EDITING” appears on the display. Then
“WRITING” and the REC (MD recording)
indicator flash while the editing you have
made is being recorded on the MD and playback stops.
When “CANNOT ENTRY!” appears on the display in
step
7
You are trying to enter the selected track into the same group again. Repeat
procedure from step
6
.
GROUP SKIP GROUP SKIP
SET
Ex.: When track 13 is selected.
SET
SET
Ex.: When group 18 is selected.
ENTER
SHIFT
Continued
EN37-45_UX-J55MD[UB]f.p65 7/1/03, 4:46 PM40