Filter
Top Products
17
English
To go to another track directly using the number
buttons
On the remote control ONLY:
Pressing the number button(s) allows
you to start playing the track number
on the current disc.
Ex.: For track number 5, press 5.
For track number 15, press +10,
then 5.
For track number 20, press +10,
then 10.
For track number 30, press +10,
+10, then 10.
To change the information shown on the display
On the remote control ONLY:
Press DISP/CHARA.
Each time you press the button, the
information on the display alternates between
the source indication and the clock indication.
• If an MD is inserted, the MD remaining recording time
(“REC REMAIN”) is shown before the clock indication.
Programing the Track Playing Order
—Program Play
You can arrange the order in which the tracks play before you
start playing. You can program up to 32 tracks.
• To use Repeat Play (see page 19), press REPEAT after
starting Program Play.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step
3
again.
1
Load discs into the 5-CD changer.
• If the current playing source is not “CD,” press CD 6,
then 7 before going to the next step.
On the remote control ONLY:
2
Press PLAY MODE repeatedly
until “CD PROGRAM” appears
on the display.
The PRGM indicator also lights up on the display.
• Each time you press the button, play mode changes as
follows:
• Program Play can only function when all disc trays are
closed.
• If a program has been stored in memory, the program is
called up.
• Once the PRGM indicator lights, you cannot change a
disc.
3
Press DISC UP or DISC
DOWN to select the disc
number you want to play.
• If “CD1*NO READ” appears on the display, press
PLAY MODE repeatedly to select Continuous Play.
Then, press DISC UP or DISC DOWN to select
the disc so that its disc information is shown on the
display, then press 7. Start from step
2
again.
* Selected disc number appears.
4
Press the number buttons
to select a track from the
selected disc in the
previous step.
• For how to use the number
buttons, see “To go to another
track directly using the number
buttons” on the left column.
5
Program other tracks you want.
• To program tracks from the same disc, repeat step
4
.
• To program tracks from a different disc, repeat steps
3
and
4
.
6
Press CD 6.
The tracks are played in the order you
have programed. Program Play ends
when all the programmed tracks are
played once (when Repeat Play is not activated).
To stop during play, press 7.
To exit from Program Play, before or after play, press PLAY
MODE once or twice so that the unit enters another play
mode (Random Play or Continuous Play).
The PRGM indicator goes off.
• Turning off the unit also cancels Program Play and changes
play mode to Continuous Play. The program you have
made is still stored in the memory until you erase the entire
program (see page 18).
PRGM (program) indicator
Disc tray number
DISP/CHARA
PLAY
MODE
DISC UP
DISC DOWN
Total playing time
Track number
Program step number
C D
PRGM
1 2 3 4 5
C D
PRGM
1 2 3 4 5
C D
PRGM
1 2 3 4 5
CD PROGRAM
(Program Play)
CD RANDOM
(Random Play)
Continuous Play
CD
6
123
456
789
10 0 +10
123
456
789
10 0 +10
EN15-19_UX-J55MD[UB]f.p65 03.7.10, 0:01 PM17