Filter
Top Products
SETUP
SDP-40
3-36
Performing Manual Output Level Calibration
Selecting the MANUAL SPEAKER SETUP menu LEVELS CALIBRATION option opens the LEVELS CALIBRATION menu shown below, which can be
used to manually calibrate output levels.
LEVELS CALIBRATIONMANUALSPEAKERSSETUP
Note the following:
• It is recommended to use a Sound Pressure Level (SPL) meter
to manually calibrate output levels. An SPL meter is a device
that measures the relative loudness of the speakers to ensure
accurate output level calibration. SPL meters are available at
Radio Shack (catalog no. 33-2050).
•Output levels should be calibrated from the primary listening
position, placing the SPL meter at the approximate location of
the listener’s head during listening.
INTERNAL NOISE
!CAUTION!
HIGH AUDIO LEVELS
!CAUTION!
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
LEVELS CALIBRATION
INTERNAL NOISE TEST
DACS CALIBRATION
BASS PEAK LIMITERS
SETUP
SETUP
INPUTS
SPEAKERS
REAR PANEL CONFIG
DISPLAYS
VOLUME CONTROLS
TRIGGERS
LOCK OPTIONS
SPEAKERS
R
C
SR RR
-18.0 to +12.0dB
SPEAKER LEVEL ADJUST
FRONT LEFT +0.0dB
CENTER +0.0dB
FRONT RIGHT +0.0dB
SIDE RIGHT +0.0dB
REAR RIGHT +0.0dB
REAR LEFT +0.0dB
SIDE LEFT +0.0dB
MONO SUB +0.0dB
SUB RIGHT N/A
LFE N/A
• Output levels for speakers that are not included in the speaker
setup cannot be adjusted during the internal noise test. These
output levels can be adjusted during the external noise test,
but there is no need to do so.
. . . Performing Manual Output Level Calibration continues on page 3-36
SPEAKER SETUP
CUSTOM SETUP
SYNTHESIS 7CH SETUP
SPEAKER DISTANCES
LEVELS CALIBRATION
+0.0dB +0.0dB
+0.0dB +0.0dB +0.0dB
+0.0dB +0.0dB
+0.0dB
L
M
SUB
R
C
SL
S
R
RL
RR