Filter
Top Products
SETUP
JBL
3-20
Configuring Advanced Input Settings (continued from page 3-19)
ANLG IN LVL -18 to +12dB
Allows adjustment of analog audio input levels for input signals
sent to the Record Zone digital audio output connectors. The
SDP-40 applies these adjustments to input signals before passing
them to the Record Zone digital audio output connectors. This
parameter can be adjusted when an input source is present to
prevent the internal A/D converter from overloading.
DIGITAL BYPASS ON, OFF
Allows digital sources to bypass sample rate conversion for direct
digital recording. When ON is selected, the SDP-40 passes digital
input signals directly to the Record Zone digital audio output
connectors, preserving the original sample rate of the input signal.
When OFF is selected, the SDP-40 sends digital input signals
through sample rate conversion before passing them to the Record
Zone digital audio output connectors, allowing the sample rate of
the output signal to match the sample rate of the recording device.
Note:
DIG OUT RATE parameter settings have no effect
when the DIGITAL BYPASS parameter is set to ON.
DIGITAL BYPASSRECORD ADVANCEDDVD1INPUTSSETUP
ANLG IN LVLRECORD ADVANCEDDVD1INPUTSSETUP
DIG OUT RATE INPUT, 44.1kHz, 48kHz, 88.2kHz, 96kHz
Controls the sample rate of digital and analog input signals sent to
the Record Zone digital audio output connectors. When INPUT is
selected, the SDP-40 does not send input signals through sample
rate conversion before passing them to the Record Zone digital
audio output connectors, preserving the original sample rate of the
input signal.
When a value is selected, the SDP-40 passes input signals through
sample rate conversion before passing them to the Record Zone
digital audio output connectors, converting the sample rate of the
input signal to the selected value. It is recommended to set the DIG
OUT RATE parameter to the appropriate value when using a
recording format that operates on a single sample rate, such as
CD-R format (44.1kHz).
RECORD BLOCKED, ENABLED
Prevents recording device feedback loops. When BLOCKED is
selected, the SDP-40 blocks the Record Zone audio output
connectors to prevent feedback loops. However, the SDP-40 still
passes video input signals to the Record Zone video output
connectors. When ENABLED is selected, the SDP-40 passes audio
and video input signals to the Record Zone audio and video output
connectors.
RECORDRECORD ADVANCEDDVD1INPUTSSETUP
DIG OUT RATERECORD ADVANCEDDVD1INPUTSSETUP