JBL SDP-40 Stereo System User Manual


 
MODE ADJUST
JBL
5-22
5.1 MONO SURR
Designed for playback of Dolby Digital mono sources.
Sends mono sources to all channels.
Parameter
OUTPUT LEVELS Refer to page 5-32
CUSTOM Refer to page 5-33
Listening mode menu parameter descriptions begin on page 5-34.
5.1 MONO
Designed for playback of Dolby Digital mono sources.
Sends mono sources to the center channel.
Default Possible
Parameter Setting Settings
SUB L/R LVL +0dB OFF, -30 to +12dB
CUSTOM Refer to page 5-33
Listening mode menu parameter descriptions begin on page 5-34.
5.1 MONOMODE ADJUST
5.1 MONO SURRMODE ADJUST
DECODING
and listening mode names differ depending on the
encoding present in the input source, the DECODING parameter
setting, and the speaker setup. The table at the top of the next
page indicates the conditions in which dts-ES decoding is engaged.
listening modes are available when dts-ES decoding is not
engaged.
•dts-ES decoding is not engaged when the DECODING
parameter is set to OFF or when the DECODING parameter
is set to AUTO and a 5.1-channel dts source is detected.
listening modes are available when dts-ES decoding is
engaged.
dts-ES decoding is engaged when the DECODING
parameter is set to ON or when the DECODING parameter
is set to AUTO and a 5.1-channel matrix-encoded or a 6.1-
channel discrete-encoded dts-ES source is detected.
listening modes are not available unless both side and
rear speakers are present.
Note:
The table at the top of the next page is not applicable
to the , ULTRA2, and
MUSIC listening modes.